Climbing Formwork CB240
Katrangan
Platform width: 2.4m
Roll-back system: 70 cm with carriage and rack system
Finishing platform: for removing the climbing cone, polishing concrete surface etc.
Anchor system: should be pre-fixed into the formwork and left in the concrete after pouring.
Formwork: can be moved horizontally, vertically and tilted to meet site requirement.
Main platform: provide workers a safe working platform
Finishing platform: there is an access to the main platform by using a safety ladder.
Kaluwihan
- Kompatibel karo kabeh formworks tembok Construccion.
- Set sing digawe saka kurung lan panel formwork dipindhah menyang langkah tuang sabanjure kanthi angkat crane siji.
- Bisa adaptasi karo struktur apa wae, kalebu tembok sing lurus, miring lan bunder.
- Sampeyan bisa mbangun platform kerja ing tingkat sing beda-beda. Akses menyang platformsis sing diwenehake dening tangga safety.
- Kabeh kurung kalebu kabeh konektor kanggo ndandani handrails, push-pullprops lan aksesoris liyane.
- Kurung pendakian ngidini nggulungake panel bekisting kanthi nggunakake sistem, sing dibentuk dening kreta lan rak, sing dipasang ing kurung kasebut.
- Formwork’s vertical adjusting and plumbing is completedwithleveling screw jacks and push-pull props.
- Brackets dipasang ing tembok kanthi sistem kerucut jangkar.
Prosedur pendakian
The first pouring is to be completed by using the proper wall elements and has to be exactly didadekake siji karo nyetel struts. |
Langkah 2 The completely pre-assembled climbing scaffold units consisting of climbing brackets with plank bottom and bracing have to be attached to the bracket anchoring and secured. Then the formwork and the move-off carriage together with the aligning beam has to be positioned on the brackets and fixed. |
Langkah 3 After shifting the climbing scaffold unit to the next pouring position the finishing platform is to be mounted to the brackets to complete the climbing system. |
Langkah 4 Release and remove bolts that fixing the positioning anchor point. Loosen lan copot tie-rod Loosen the wedges of the carriage unit. |
Langkah 5 Retract the carriage and lock it with wedge. Pasang cones climbing ndhuwur Loosen piranti ngamanake angin, yen ana Copot conthong climbing ngisor
|
Langkah 6 Adjust the carriage into the common center of gravity and lock it again. Pasang sling crane menyang waling vertikal Copot bolts keamanan krenjang Lift the climbing bracket by crane and attach it to the next prepared climbing cone. Lebokake lan ngunci baut keamanan maneh. Pasang piranti beban angin, yen dibutuhake. |
Langkah 7 Move the carriage back and lock it by wedge. Ngresiki bekisting. Pasang bar tulangan. |
Langkah 8 Move the formwork forward until lower end rests against top of the finished section of the wall Setel bekisting vertikal kanthi push-pull brace. Ndandani rod dasi kanggo bekisting tembok |